-
Isolation Transformer for Airport Lights
Isolation transformer used in the series circuit of airport lights. Components: A transformer shall include a primary coil and a secondary coil wound on an iron core, a waterproof casing, and primary and secondary leads with plugs or sockets extending from the casing. Specifications: Isolation ...Read more -
Airport Rotating Beacon
Application 1. Each airport prepared for nighttime use must install airport rotating beacons or identification beacons where necessary for operation. 2. The determination of operational requirements must take into account factors such as the air traffic requirements usin...Read more -
Airport Windcone
Application Airports must have at least one windcone. Location The windcone must be installed so that it is visible to aircraft in flight or over the activity area and is not affected by airflow caused by nearby objects. Features Recommendation: The windcone should be a truncated cone shape, ma...Read more -
What are the structural requirements for Elevated Heliport Lights?
1. Frangibility Luminaires installed on the pavement shall have a break point near the location where the luminaire is connected to the base or mounting device. The break point shall not exceed 38mm above the pavement (the break point of a vertical direct-mounted ...Read more -
Final Approach and Takeoff Area Light(FATO)
A surface heliport should have at least one FATO and should meet the following requirements: 1. When used for helicopters operating at Level 1 performance, the size of the FATO (Flying Air Frame) shall be determined according to the specifications in the helicopter flight manual. If no width is ...Read more -
Aircraft Warning Spheres on High-voltage lines: Functions and Installation requirements
Introduction The colored aircraft warning spheres hanging on the high-voltage lines are 600mm in diameter and made of engineering reinforced plastic. They are firmly connected to the cables through cast aluminum wire clamps. They not only provide visual warnings for helicopters to prevent low-a...Read more -
What is the Size of a Typical Heliport Design?
According to Article 25 of Chapter 3 of the International Civil Aviation Flight Rules, the takeoff and landing area of a helicopter should be determined based on specific circumstances, and the diameter of the takeoff and landing site area should be determined according to the aircraft model. It...Read more -
How to Install Aircraft Warning Light on Wind Turbine: Types, Location, and Installation Spacing
As the demand for renewable energy continues to rise, wind turbines have become a common sight in many regions. However, their towering structures pose a potential hazard to low-flying aircraft. To mitigate this risk, the installation of aircraft warning lights on wind t...Read more -
Airfield Runway Edge Lights: Purpose, Colors, and Spacing
Airfield runway edge lights are essential components of airport infrastructure, playing a critical role in ensuring the safety and efficiency of aircraft operations during takeoff and landing. These lights serve multiple purposes, including guiding pilots, enhancing visi...Read more
